Preparation before use
(1) Please make sure the battey Hugo Vapor Pathfinder you’re using corepond with the BTTERYWARNING CARD.
(2) Before vaping, please make sure the pod is flled with enough ejuice.
(1) Slide and open the battery cover as the picture shows;
(2 )Place two 18650 batteries into the device according to the correct directíons;
(3) Close the battery cover.
SCAR-18 uses a spring loaded 510 connector. Please be certain thatthere is nothing between the Mod and the attached atomizer.
(1) Connect the atomizer to the device and tighten it clockwise.
(2) After the device is powered on, please press the Fire Key to vape.
1. Power on
While the device is off, quickly dick the Fire Key5 times in 2 seconds to turn it on Uwell Caliburn KOKO Replacement .
While the device is on, press and hold the Fire Key to vape (it will be forced to stop working when the vaping time exceeds 8 seconds, release and press again to vape).
3. Button features
(1) Press the UP and DOWN buttons simuitaneously to lock or unlock thewattage adjustment function;
(2) Press the Fire Key and UP button simultaneously to switch between thesix theme colors;
(3) Press UP or DOWN Button to adjust the temperature or wattage settings.
4. Menu Settings
Press the Fire Key 3 times to enter menu setting interface; press the UP/DOWN Button to switch between “POWER”,”TC-TI”,”TC-Nl” and”TC-SS”.
Press the Fire Key to select the item tobe adjusted VAPJOY DIY Rebuild Kit for Uwell Caliburn .
COlL: set the atomizer resistance, range-t100mQPUFF.dear the number of puffs.
TC MODE (TC-NI/TC-TI/TC-SS)
Press the Fire Keyto select the item to be adjusted.
COIL set the atomizer resistance, range ±100mΩ
WATT: set the Tc preheat power, range: 10W-230W
TCR： set the temperature coeffcint of resistance, Uwell Caliburn KOKO Vape Pod System range: N: 400-800T:200-500, SS: 10-300
PUFF: clear the number of puffs
5. Power Off:
While the device is on, quickly press the Power Button 5 times in 2 seconds to turn it off. The screen displays “POWRE OFF”.
How to fill with e-liquid:
(1) Hold the tank with one hand, lift and open the top cap.
(2) Add e-liquid through the slot and pay attention not to drip it into the central airflow tube.
(3) Close the cap carefully and firmly. Then let it stand for several minutes to getthe organic cotton completely saturated.
Replace atomizer core:
First, unscrew the base, then unscrew the coil head from the base, thensecure your new coil head onto the base plate (ensure that itis screwed insecurely), finally screw the new coil head into the chimney and you’re readyto prime your new coil head.